|
Post by dizzy on Jun 18, 2019 21:29:02 GMT -6
What's the point in CV conversions existing in the first place when you can't design them because the 'Design board' requires 8 x 6 in guns and any turret you put on is a rebuild error because it's new?
Edit, fixed. Found a bug and discovered a workaround. See my next post below.
|
|
|
Post by rimbecano on Jun 18, 2019 21:54:43 GMT -6
When I've run into this problem, I've been able to work around it by using single, rather than double turrets. Oddly enough though, I think I've had it let me place new 8" doubles, but refuse 6" doubles.
|
|
|
Post by dizzy on Jun 18, 2019 21:58:07 GMT -6
Ok, I figured it out. I inadvertently discovered a bug of sorts. The 'check design' warning box was displaying incorrect information when I lowered my Main Guns of 10" to 6" to satisfy the 'design board' requirement of having 8 x 6 in guns on my design while I had reduced my secondary of 6 in guns in number from 12 to 0. So there's your bug. It should have correctly seen that there were no secondary guns but it bugged up and I thought I couldn't complete my conversion.
I rectified this problem by first reducing my secondary guns to 5 in and then reducing my main guns to 6 in. Then the check design function reported the proper information.
|
|